![how to edit reinforcement diameter in etabs 9.7.4 how to edit reinforcement diameter in etabs 9.7.4](https://i.ytimg.com/vi/ETaTDoTSRYk/maxresdefault.jpg)
- How to edit reinforcement diameter in etabs 9.7.4 how to#
- How to edit reinforcement diameter in etabs 9.7.4 full#
- How to edit reinforcement diameter in etabs 9.7.4 code#
This section can be defined using the section designer that is built in ETABS wherein the designer can create any geometrical shapes. Uniform Reinforcing Assignment to Pier 3.
How to edit reinforcement diameter in etabs 9.7.4 how to#
READ ALSO: How to Design Spandrel or Coupling Beams in ETABS The interpretation of these results will be further explained in the upcoming articles to be published soon. The reinforcement provided is then verified if passed or failed by going to Display>Show Table>Shear Wall Summary. You can either tick the Reinforcement to be Checked and Reinforcement to be designed. In the following figure, the designer has the option to select which bar size and spacing to provide. To do this, the designer should select the pier section or the wall to design and go to Design>Shear Wall Design>Uniform Reinforcing and the figure below will appear. In this option, the sections assigned as pier will be designed or checked for the uniform reinforcing that the designer assigns. For boundary zones checks and shear design, it analyses the pier sections up into the planar legs and then performs the design and analysis on each leg separately.
![how to edit reinforcement diameter in etabs 9.7.4 how to edit reinforcement diameter in etabs 9.7.4](https://i.ytimg.com/vi/bjZpT3FXYGA/maxresdefault.jpg)
For flexural design or check, the previously defined pier section is automatically picked up by the program and do the design or check.
![how to edit reinforcement diameter in etabs 9.7.4 how to edit reinforcement diameter in etabs 9.7.4](https://reader020.staticloud.net/reader020/html5/20190728/55cf8d075503462b139174ab/bg3.png)
The uniform Reinforcing option is applicable to either design or check both planar walls and coupled shear walls (spandrels). This design option is best to use to determine and design the boundary zones or the boundary elements of shear walls, especially in high seismic areas.
How to edit reinforcement diameter in etabs 9.7.4 full#
When dealing with shear design the full length of the pier section and reports the required shear reinforcing per unit length. The program will report the required width of the edge strip to resist the axial and overturning moment required reinforcing in the governing compression and tension load combination. READ ALSO: 10 Checklists in Reviewing ETABS Model Or you can refer to the figure below screenshot from ETABS interface. In the ETABS analyzed model, go to Design> Shear Wall Design> Assign Pier Sections. How to Perform ETABS Design/Check of Shear Wall When the pier section is specified to check for the rebar details specified by the designer, the program creates an analysis to determine the flexural demand/capacity ratio, the required area for shear rebar for the selected pier and other output results to determine whether the section is passed or failed.
How to edit reinforcement diameter in etabs 9.7.4 code#
In an ETABS analyzed model, the program can perform the following design/check, the procedure in accordance with the specified code requirement: When you require the program to do the design, choose the Designed option and Checked when you let yourself assigned the wall reinforcement to be verified by the program. The designer can be opted to either use the Reinforcement to Designed or Reinforcement to be checked option. It is not only limited in the analysis of walls but it can also perform the design and check. One of the useful tools in ETABS program is the Shear Wall Design capability. ETABS Shear Wall Design, General Reinforcing, Shear Wall Design, Simplified C&T, Uniform Reinforcing